4/16/2023 0 Comments Gns3 cisco 7200![]() ![]() Note that R7 and R8 are Nokia 7750 routers and R9 is a Cisco 7200 router.Ī VPRN 200 is setup on the three routers. The following shows the lab setup on GNS3 on the same Windows 10 PC used in the previous ePipe interop article. This time, LDP and MP-BGP are used as the signalling protocols for establishing the MPLS Transport and Service Tunnels respectively for the layer 3 network service. In this article, I will show how to setup and test layer 3 MPLS VPRN network service between Nokia 7750 and Cisco 7200 again on GNS3. Since ePipe is a layer 2 network service, the virtual PCs connected at the two ends of the MPLS ePipe on GNS3 need to be on the same IP subnet in order for the PCs to ping to each other. RSVP-TE and TLDP are used as the signalling protocols to establish the MPLS Transport and Service Tunnels respectively for the MPLS ePipe service. ![]() In my previous article, I showed how to setup and test layer 2 MPLS ePipe Pseudo Wire network service between Nokia 7750 and Cisco 7200 routers on a Windows 10 PC running GNS3. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |